Pop-top

1. Start inside the van with a window or door open. This stops a vacuum forming.
2. Push down on one of the clips above the seats and pull the strap to loosen it most of the way. Repeat on the other side. A good guide: pull until the end of the strap is level with the bottom of the headrest.
3. Gently push up on the roof. Sitting on the swivelled front seat helps.
4. The roof will release and begin to lift slowly.
5. Unclip the strap across the roof before lifting the bed.
6. To lift the bed, stand in the middle of the camper and press up just after the hinge, towards the opening at the front of the roof.
7. Make sure the habitation vent is open.
8. Unzip the canvas windows and fly nets for extra light and ventilation.

1. Start inside the van with a window or door open. This stops a vacuum forming.
2. Make sure all openings are zipped and both internal bungee straps are fastened across the bed. This helps the canvas fold in.
3. Gently pull the bed down from the edge.
4. Using the straps, pull the roof down until it holds itself in a semi-closed position.
5. While holding one strap, use your free hand to gently pull the canvas inward from the sides and front, so it cannot catch or get trapped under the roof.
6. Fold the canvas neatly as you go. Make sure it is tidy and will not block your view while driving.
7. Check all the canvas is pulled in well. Looking from outside can help.
8. Pull the roof down the rest of the way.
9. Fasten the straps and tighten until the roof is completely flush.
10. Check the straps are fully secure. Tuck any excess strap as far in as possible at the sides so it cannot fall loose while driving.

If the roof springs back up: the canvas is too bulky. Open it and fold the canvas more carefully.

1. Take off your shoes.
2. Stand on the swivelled passenger seat.
3. Place your hands shoulder-width apart on the top edge of the bed.
4. Pull your torso up using your arms.
5. Bring one knee or foot up onto the platform.
6. Shift your weight onto that leg, then bring the second leg up. Now you are up and able to make your bed.

1. Move to the edge of the bed and carefully let your legs hang down.
2. Lean over slightly and place both hands firmly on the seat headrests.
3. Lower one foot to find the surface of the seat.
4. Shift your weight gradually onto the lowered foot.
5. Lower the second foot.
6. Let go with your hands only once you are fully stable.

Regular care keeps your pop-top in top condition, protects it against wear and tear, and helps it perform reliably for years, even after the warranty expires.